High Performance Forged Steel Con Rod H Beam Set (Abarth/Fiat/Alfa Mito 1.4 16V Turbo)
Manufactured from forgings originally produced in Sweden, PEC connecting rods have offered engine builders and tuners a cost efficient and yet high performing solution to a wide variety engine building problems.
H-Beam and I-Beam section connecting rods are forged from AISI 4340 (En24) steel. Heat treated to HRC 35-38 and then shot peened for a higher fatigue strength.
Small ends are bushed for a fully floating pin and big ends are fitted with high quality ARP fasteners with different specification bolts available depending on the level of performance required.
PEC Connecting rods have been designed, manufactured and tested to the highest levels of scrutiny before being released to the trade and the public.
Engine TypeFiat 500 Abarth 1.4 16v Turbo
Small End Diameter18.00mm
Small End Width15.50mm (chamfered)
Big End Diameter45.13mm
Big End Width21.70mm
Bolt SpecificationARP2000 5/16 Thread
PEC rods are designed to withstand roughly 225hp per cylinder (typically 900hp on most 4cyl engines) and on the ARP 2000 series 3/8 bolts normally provided & have an 8,500 RPM safe operating limit (engine specific).
What's in the box?
4 x forged steel connecting rods (choose between H-beam or I-beam style
8 x ARP 2000 series
1 x ARP fastener assembly lubricant
1 x PEC connecting rod installation guideline sheet
Please contact us to check delivery time before ordering this product.